Guide :Grilling : VGBQ300T (NG) All-in-One Grill / Smoker

Flame is too small, does not get hot enough.

This grill is in a salt water environment - ocean less than 100 ft away. The left knob to increase the heat has become very hard to turn. Coincidentally, when this happened, the flames will not go very high, on either side. We know there is fuel, but there is not enough heat to cook food.

Research, Knowledge and Information :


How to Troubleshoot a Gas Grill With a Low Flame | Home ...


How to Troubleshoot a Gas Grill With a Low Flame. ... debris and small insects who like to call the ... My Grill Has Low Flames and Will Not Get Hot Enough to Sear My ...
Read More At : homeguides.sfgate.com...

Gas flames are not hot enough. How to adjust flames


Gas flames are not hot enough. How to adjust flames ... setting on the flames on both the large and the small burner and the grill insert does not get hot enough to ...
Read More At : www.justanswer.com...

Why does my grill have low flames and not get hot enough to ...


FAQ Troubleshooting Why does my grill have low flames and not get hot enough to sear my food ... Do not put excessive force on the valve at the full open ...
Read More At : www.sabergrills.com...

Gas furnace not enough heat - Gray Furnaceman Furnace ...


Gray Furnaceman Furnace Troubleshoot and Repair. ... because if it does not sense flame well it will ... is too small. I would caution that this is not often ...
Read More At : www.grayfurnaceman.com...

Why Won't My Gas Grill Get Hot? - Home Ec 101


Why Won’t My Gas Grill Get Hot? By Heather Solos ... I just couldn’t get the flames high even with the burners wide open. ... I want one of those, too -not ...
Read More At : www.home-ec101.com...

research » Adjusting the simmer flame on a gas stove


Adjusting the simmer flame on a gas ... My small screwdriver shaft was not long enough, ... ago and have been struggling with the burners that are too hot even on ...
Read More At : research.rolfes.org...

Gas Oven Repair Manual - Chapter 6 | Gas Oven Pilot Flames


... are too small to ... not pilot flame. The only function of these pilot sensing elements is to prevent gas flow to the burner if the bulb does not get hot enough ...
Read More At : www.appliancerepair.net...

Troubleshooting Guide - Candle Cauldron


Pouring temp too hot. ... Flame too small: Wick too small: ... Not enough fragrance. Fragrance burned away too much before pouring.
Read More At : www.candlecauldron.com...

Suggested Questions And Answer :


Flame is too small, does not get hot enough.


This sounds like it probably is a regulator problem - they tend to corrode very quickly in salt environment - i live on the coast too and have the same problem often. First thing to try is to spray a little WD40 or similar into the regulator. often they will have a tiny hole somewhere in the body of the regulator usually on the side away from the gas bottle but there are many different types - spray in this hole in particular. Then give the regulator a bit of gentle violence - often the spring plate inside can stick or the valve itself and this can free it up. No luck with this then get a new regulator - they are not usually expensive - make sure the regulator is the correct type for the gas you are using, they have different pressure settings for propane, butane, and all the assorted mixes. The sticky left Knob is unlikely to affect the gas flow, although there must be some corrosion to make it hard to turn so it is possible that this has gone into the valve/pipe behind the knob - sometimes these valves can be dismantled and cleaned fairly easily, some are sealed units that just have to be replaced - if you want to try and are not sure what to do, try posting back with some photos and i could try and talk you through it, or try getting me on a live chat armed with photos, some WD40 and a selection of basic tools and some steel wire wool (stainless if possible). Hope this helps and we can get you grilling for the summer, please ask again if not :)
Read More At : VGBQ300T (NG) All-in-One Grill / Smoker...

I have my Weber Q grill hooked up to a large propane tank rather than the small tube type. It worked fine for a few weeks but now the grill only gets medium hot. Not hot enough to cook anything really. I went to the store and replaced the long connecting tube whcih connects to the grill and the tank. It worked once and the grill got hot but last night it only got medium hot again and I could not use it. It appears that the rear of the heating / gas coil does not have a flame. The front of the coil does. What is causing this or what do I need to replace. The grill is only one season old.


Seems as if your grill is suffering from "Clogged Burner Syndrome". But, don't despair, it's easily solved by removing and thoroughly cleaning the burners or "coil" as you called it. Also, pay particular attention to the venturi valves on the open end of the burner. Spiders like to build nests in them. The venturi valve will look like a slot on the right and left of the burner tube, where it fits over the burner orifice. It's really a good idea to perform this routine maintenance, at the start of each grilling season.When it comes to gas grills, it's like Benjamin Franklin said, "Cleanliness is next to Godliness."Hope this helped you solve the problem. Happy Grilling!!
Read More At : Q Grill...

I do not think my Brinkman smoker is getting hot enough. I was able to cook three split chicken breasts and eight wignettes, but this took over four hours! I am using the smoker outside of my garage so I have an extention cord running to the outlet. I know this sounds crazy, but is it possible the cord is too long? I've heard of output being degraded over a certain period and was just wondering. This is a very heavy contractor type of cord. I do not have an outlet located where I can plug the smoker in directly. What would cause the element not to reach the proper temp? I just replaced the element because the one before didn't work at all.


I really don't think the problem is with the extension cord, as long as it it's at least a 12 or 14 gauge.I'm assuming you remove the heating element and pan from the smoker body to grill foods. If not, you're not grilling you're smoking. Which is low and slow cooking. Temperature that doesn't exceed 250 degrees F. So, if you were smoking the chicken ****** and wing-lets, 4 hours does not seem unreasonable.Right now, the best thing you can do, is purchase an inexpensive oven thermometer (that sets on the oven rack in a conventional oven) to accurately determine what the temperature is, when you smoking or grilling.In case you have misplaced the Owner's Manual, I have included a link to it that you can download & print for future reference. http://images.brinkmann.net/docs/pdf/810-7080-K.pdfI hope this helped you and thanks for choosing FixYa.
Read More At : 810-7080-K All-in-One Grill / Smoker...

I cannot get the extra large big green egg hot enough it goes to 300 but really no further. With my leaf blower- blowing air into the intake i got it up to 400 but no further- this is the second time it did not get hot enough the dealer sold me some charcoal from hawaii should i use only big green egg charcoal


Yes use ONLY Big Green Egg Charcoal If you use anything else you can damage it
Read More At : Extra Large - XLHD All-in-One Grill / Smoker...

I have a traeger bbq 100 that has worked great for 3 years, but now it will not get hot enough. The auger turns properly, so my only thought is that it is not turning fast enough to feed the proper amount of pellets to reach higher temperatures. Any advice?


I changed the biscuits on mine, and it got hotter
Read More At : BBQ100 All-in-One Grill / Smoker...

I have a KBNU367TSS and I am having problems with 3 of the 4 ignitors. Two of them will not work at all and one of them gets red but not hot enough to ignite the gas. The rear burner ignitor works fine. The cost for each new ignitor from Kitchenaid is like $90.00 each. Anyone know what the problem is or where I can find the part for less money. Can this problem be fixed without replacing the ignitor? Any help would be appreciated.


One problem with glo plug ignitions is the loss of voltage across the glo plug. Each glo plug has to have the correct amount of current to get hot enough to light the gas. If the current is to low, the plug will glow, but not light the gas. You have to open the grill up and check the wiring, etc for shorts, bare spots in the wires insulation, etc.
Read More At : KBNU367TSS Gas All-in-One Grill / Smoker...

It won't put out enough gas to cook. Can only use one burner at a time because it will not put out enough gas volume or pressure to burn more than one. And that one has to be on high in order to get enough flame to cook as if it were on low. I've changed the regulator, the gas bottle( several times) and blew air through the lines to be sure the lines and the burners were not obstructed. What would be your next suggestion. Because for what I paid for this unit and the very few times I have been able to use it without cussing and trying to figure out why it can't do something as simple as blow gas through a line, I think someone should be replacing it with something else comparable. That would my suggestion. Because I love to grill out and feel sick everytime I look at $700.00 worth of new junk sitting there unusable.


Many newer grills have a safety feature built in where the valve will not allow gas to flow if the burner valve is in ON position when the valve on the tank is opened. Try this - Shut of all valves, disconnect and then re-connect hose to tank, turn on valve above LP tank, THEN turn on burner valve, light w/ spark or match... This feature can be really frustrating if you don't know it is in operation...
Read More At : 810-8905-S Stainless Steel Propane All-in-One Grill / Smoker...

I have a Traeger 100 BBQ. I can not get it to produce enough heat, it takes so long, and can not use at all if the weather is cool. I think the burner is to small for the size of it.


Hi, Your problem could be or probably is with the regulator...not enough gaspressure...Propane, LP, or Natural Gas Regulator Problems heatman101
Read More At : BBQ100 All-in-One Grill / Smoker...

Commercial Stainless Steel Grill: Have a small blue flame but the flame is not large...


The burner could be blocked or the orffice try cleaning them
Read More At : Commercial Stainless Steel Grill...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mainebirdfood.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0924 seconds