Guide :Grilling : 30400040 Stainless Steel Grill

Ducane 3400042 lighting problems

Just purchased 8/12/07 and rotisserie light won't light;igniter sparks but will not light. None of the burners will light with igniter(it does spark) but will light with flame! Help Paid too much to have a big beautiful grill that doesn't work. Linda

Research, Knowledge and Information :

Ducane Grills - Ducane - All Parts Grills

Ducane Grills replacement gas grill parts are available at allpartsgrills.
Read More At :

Ducane furnace does not light. - DIYChatroom

Ducane Furnace Model FP ... Ducane furnace does not light. ... I have been servicing furnaces for over 10 years but I have not been able to solve this problem this ...
Read More At :

Ducane Natural Gas Unit Running, Not Igniting or Trying to ...

My Ducane gas furnace is refusing to light, ... Ducane Natural Gas Unit Running, Not Igniting or Trying to Ignite; ... same problem again, ...
Read More At :

Ducane 30400042-30400043 5 Burner - All Parts Grills

Ducane 30400042-30400043 5 Burner grill parts and accessories available at allpartsgrills.
Read More At :

Gas Furnaces - Ducane|Residential Heating and Cooling|Home HVAC

Ducane furnaces are built with quality materials and are designed for optimum performance and energy efficiency.
Read More At :

Ducane Grills

Gas grill manufacturer. Information for dealers, promotions and recipes.
Read More At :

Ducane|Residential Heating and Cooling|Home HVAC

Ducane. That means you’re going to enjoy reliable, worry-free heating and cooling today, and long into the future.
Read More At :

Fixes for Common Gas Grill Problems - Make Your Best Home

Common Gas Grill Problems Quick and easy fixes to most gas grill problems. By Derrick Riches. ... Gas Grill Just Won't Light: Some grills have push-button ...
Read More At :

Suggested Questions And Answer :

None of my igniters on my 30400043 Ducane grill will light the burners. I've had a grease fire due to the burners rusting out and replaced the burners. The insulation on the wires to the igniters has burned off. Do I need to buy a whole new manifold or is there replacements for the igniters? Do the clickers go bad? I'm very disappointed. I bought this grill 3 years ago thinking it's the last I'd have to buy and here I am replacing parts 3 years later. I also don't think the infra red elements are getting hot enough. When running they can be blown out. I don't use them often and have run it for 45 min or so and got a steady flame. I'll try the rotisserie tomorrow. It'd be a shame to waste a good piece of meat. Anyone else having these problems? Got solutions?

As I tell customers, when they ask me, "How long will this grill last?" "That depends on well you take care of it with routine maintenance and cleaning."The wiring for the electronic ignition and the spark ignitors are replaceable. The ignitor button or the "clicker" as you called is replaceable. But all you may to do, is change the battery inside the igniter button. To help you further, i have included a link to the Owner's Manual for your grill. It will have an exploded view of the parts, which should help you identify them by part number and order them from Ducane, if you like. far as the infrared burners are concerned, they blow out easily if the wind is just blowing slightly. That's why they have a thermocouple on the burner, to turn the gas off to it, when it gets blown out. When preheating an infrared burner, the hood/lid of the grill should be closed.I hope this helped you and thanks for choosing FixYa.
Read More At : 30400040 Stainless Steel Grill...

I have a stainless steel Kenmore propane grill, model 119.16311800. It has four burners and a side burner on the left. It is two years old and has performed perfectly for two years. I am now having trouble with the flame. It will light and if I only have one burner on it will give a good flame. Lighting additional burners will reduce the flame size, when all four main burners are on they struggle to stay lit. We recently moved, and the grill was out of gas for an extended period. The problem first presented after a relative gave me a gas tank. Initial inspection showed some debris in the valve of the tank itself. I tried removing the debris from the tank with partial success. I connected it to the grill and had the same issue. Got a new tank. Fired up and cooked up some great burgers. thought I was all set until the next time when the new tank also produced the same results. I have not been able to disassemble the burners to check/clean the venturi tubes. (ever) It appears that there is a screw at the rear of the burners that will release it, but they are badly corroded and will not come out by standard means. If you could confirm this is indeed the proper way to remove the bruners I will drill them out and devise a better way to fasten them afterwards. Also, I did read here about opening the gas tank valve very slowly. I disconnected the regulator, waited a few minutes, reconnected and opened very slowly. Light the furtherst burner first and proceeded to find the problem still existed. I understand that the regulator may also be faulty. Given that there is no gauranteed life cycle for any product, can you estimate a typical life span for a regulator? How would I go about checking the regulator? I fear that when I tried to remove the gunk in that old tank some loose particals may have gotten into the regulator and damaged it. Thank you very much for any assistance you can give!

With all the you described, your best bet is to replace the grill hose/regulator assembly. It's not expensive and it's not difficult to do. You can find the hose/regulator assembly at any home center or hardware store that sells gas grills. The assembly is universal, but take your old one with you for comparison purposes.As far as replacing the burners are concerned, that's not difficult either. And you may be able to find the replacement burners at , as they made the Kenmore grills for Sears. And yes, the scenario you gave for removing the burners is correct.Hope this helped you and you will be kind enough to give my response to you, a positive rating.Happy Grilling!
Read More At : Kenmore...

I have a Ducane 30400040 LP stainless grill. Purchased a conversion kit to change to natural gas from Ducane (complete valve, manifold & igniter assy. All works fine except infra red burner will not light either with electric igniter or match Should orofice be changed at inlet to infra red burner? I have check all the way from gas line to inlet orofice - no obstructions.

Http:// The IR Burner has it's OWN ignition system, If there is any problem, the burner will NOT ALLOW, itself to be lit. You must have a sensor that is stopping it from getting the gas? You need to check, your igniter wire and also, the safety cut out.
Read More At : 30400040 Stainless Steel Grill...

Only one burner will light, no temp over 300, need to clean but no manual where can i see a manual for cleaning what is the safety valve Problem with the Brinkmann Charmglow Stainless Steel LP Drop-In 4-Burner Grill 810-6805-0 (LP)

Hi, ask the Grill & BBQ manual search engine, they will get it within hours.
Read More At : Charmglow Stainless Steel LP Drop-In 4-Burner Grill......

Grill will not light - Ducane 30400040 Stainless Steel Grill

If the ignitor is working (producing a spark) and there is no gas when the valves are opened, try replacing the regulator.
Read More At : 30400040 Stainless Steel Grill...

Ducane 3400042 lighting problems

Good answer... but remember (if you have the regular burners on... The Rotisserie will not light.) 1. Cut all knobs off... Then push and hold in Rotisserie button as you turn to high. 2. Press ignition button, until you hear rotisserie ignite. 3. Keep holding in the rotisserie button until the thermostat realizes the gas is on and burning. (IT must get hot enough to keep gas flowing.) Hope that helps, Dave
Read More At : 30400040 Stainless Steel Grill...

Pro Series 2400: I can't light the grill. I

If you hear gas going to the burners then you need to clean your grill if you don't then it a bad regulator
Read More At : 810-8410-S Stainless Steel Propane Grill...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0559 seconds