Guide :Grilling : GGR62 Grill

Broken piece connecting timer and thermostat

The black, plastic piece that connects the timer shaft to the thermostat is broken (underneath the hood assembly). When fully assembled, the shaft doesn't fit into the broken piece to set timer and thermostat. I just need to know how I can get a new piece. Thank you.

Research, Knowledge and Information :


How to Check a Thermostat in a Dryer: 5 Steps (with Pictures)


How to Check a Thermostat in a Dryer. ... or found that your dryer was not shutting off at the timer, the thermostat may be the ... Replace a Broken Drive Belt in a ...
Read More At : www.wikihow.com...

How to Tell If Your Home Thermostat Is Bad - SF Gate


The thermostat detects the temperature of the room and compares it to the ... How to Know if Your Air Conditioner Is Broken; How to Test the Thermostat on a Gas ...
Read More At : homeguides.sfgate.com...

Radio Thermostat Clock - Ferroli UK


The Radio Thermostat Clock is a 7 day radio frequency (RF) wireless thermostat/ timer which communicates with a special receiver designed
Read More At : ferroli.co.uk...

Tips on Troubleshooting Your Home Thermostat - Advice


Tips on Troubleshooting Your Home Thermostat. ... my husband said as he was hooking the old one back up again and connecting ... Would a broken thermostat prevent ...
Read More At : www.realestate.com...

Refrigerator Repair Help, Troubleshooting, and Parts


Provides free refrigerator repair help and troubleshooting. ... If your refrigerator door seal is broken, ... If the thermostat is faulty, ...
Read More At : www.appliancepartspros.com...

832085 GB 02 Futu - Vaillant


the connector nearest to the timer. The plug at the end of the cable is required when the timer is used as a ... Connecting a room thermostat 5. Timer operation
Read More At : www.vaillant.co.uk...

Troubleshooting A Home Furnace Thermostat - PREFERRED HOME REPAIR


Common Thermostat troubleshooting for Honeywell, White ... is on before assuming you have a broken thermostat. ... short piece of wiring with the ends stripped ...
Read More At : preferredhomerepair.com...

replacing defrost timer refrigerator - Appliance Repair Forum


Refrigerator & Freezer Repair. " ... (see below for the broken road that led me ... KENMORE 363 still not freezing after replacing defrost timer, heaters and thermostat:
Read More At : forum.appliancepartspros.com...

Thermometers, Thermostats, and Timers - LLLReptile


Thermometers, Thermostats, and Timers. ... Special includes the DBS1000 Helix Thermostat, the Appliance Timer Adapter Cord and the $25 ... then connect any type of ...
Read More At : www.lllreptile.com...

Suggested Questions And Answer :


Broken piece connecting timer and thermostat


These are the guys you need to speak to; http://www.esalton.com/control/contactus 1-800-233-9054 Hope this helps - please ask again if you get no luck from them :)
Read More At : GGR62 Grill...

Name & source for quick-connect LP gas tank adapter piece?


Did you find what you needed? I have the same problem.
Read More At : Stainless Steel Gas Grill...

The attachment piece from the gas line going to my grill that tightens the connection to the propane tank has cracked. I have a Vermont Castings VM400XBP. Any advice on how to fix it?


Replace it you can get this at Home Depot or Lowes it is call a Regulator
Read More At : VM448KP Propane Grill...

I have a Kenmore grill and when I went to pull the gas tank off to get it refill a tiny plastic circular piece fell out of the connection. When I reconnected it it did not supply gas to the burners. I suspect this plastic ring is the issue. Any ideas?


Yes, it may be the plastic ring, if you didn't reinstall it. However, it could be something else. The gas regulator may be locked up. To solve this problem, do the following : 1. Turn the gas tank valve OFF and disconnect the hose from the tank. 2. Wait 5 minutes and reconnect the hose to the tank. 3. Open the tank valve VERY, VERY SLOWLY (Slow motion, slow). 4. Once the tank valve is fully open, light the burner farthest from the tank first and set the burner control knob on HIGH. Does the flame height look correct for being set on HIGH? If so, light the remaining burners the same way. Do all the burner flames look correct? If so, you solved the problem. Remember, to always open the tank valve Very, Very Slowly. If that didn't solve the problem, you will need to replace the grill's Hose/Regulator Assembly. It runs about $30.00 at any home center or hardware store that sells grills & accessories. If you replace it, turn the tank valve ON Very, Very Slowly. Hope this helped you to troubleshoot and solve the problem. Happy Grilling!! Thanks for choosing FixYa.
Read More At : 882 sq. in. Cooking Area Gas Grill 14117329...

I have a only used 2x fire and ice. I have everything connected to a large propane tank. i can hear gas when i turn on but it will not light. what do or can i do.


Shut off the propane tank and see if your regulator tube is blocked. If not blocked it could be that one has to have either regulators open to allow the gas to go through and wait for the count of 5 before hitting the ignite button.
Read More At : Grill2Go Fire+Ice...

How to connect side burner correctly?


Slide the tube onto the rear of the knob and then set into place and put nut on. as long as the tube fits over the brass nipple, it will work
Read More At : Genesis Silver B Grill...

Uniflame gtc1205whl I'm not sure if we are missing a part or whatnot but the standard 1lb propane does not connect to the grill burners. The piece from the regulator to the gas chamber in the grill is not sealed. Am I doing this wrong or how can I find the part I need?


Read the owner's manual to find all the pieces. I'm sure you're missing a part
Read More At : Grilling...

The igniter connection does not have the white cover to the side burner so part of the igniter metal is exposed. When I look at other grills, there is a white couplilng type piece so the igniter wire


It'll be fine...A tiny explosion happens anyway when a grill is lit.. Its just a ceramic fitted piece... Its ok...you can still grill..;-) if you replace you'll have to replace the whole ignitor.Have fun grilling....
Read More At : Grilling...

My BGE(Large) is from 1970s 'Nam and rusting away; need parts


Once the epoxy cures completely, the solvents/liquids are gone, otherwise it would never cure. Buy a good quality one for use on cooking containers like the BGE.
Read More At : Large All-in-One Grill / Smoker...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mainebirdfood.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0734 seconds