Guide :Grilling : Grilling

Gas grille won't light - Grilling

Posted by reodbone49 on Apr 17, 2008

Research, Knowledge and Information :

How To Light a Propane Gas Grill - YouTube

Apr 16, 2012 · Find hundreds of grilling recipes: ... How To Light a Propane Gas Grill ... If the grill doesn't light, turn off the propane. Once the gas has cleared, ...

How to Light Your Grill Manually - YouTube

Apr 15, 2015 · If you have a gas grill and need to light your grill manually, ... 39. Grilling Every Season 65,932 views. ... Weber Gas Grill Won't Light Solutions ...

Weber Grills at Lowe's: Gas Grills, Charcoal Grills and Grill ...

Shop Weber Gas Grills, Charcoal Grills, Smokers and all your other grilling needs at Lowe's ... Grill With Weber Grills and Lowe’s.
Read More At :

LED Grill Lights | HomeWetBar

Grill Lights; Grilling Tools; ... Adjustable Handle Clamp Grill Light: $39.95 (6) ... With our selection of grill lights you won’t have to put up the tongs just ...
Read More At :

Why Won't My Gas Grill Get Hot? - Home Ec 101

Why Won’t My Gas Grill Get Hot? ... Now turn on the burner and light the grill. ... Very helpful thanks turned gas on waited 10 sec back to grilling. Reply. Mojo on ...
Read More At :

Weber - Gas Grills - Grills - The Home Depot

Shop our selection of Weber, Gas Grills ... Cadac introduces the 39 000 BTU Stratos 3 ... Designed for ultimate versatility the grill sample grilling space full ...
Read More At :

sunbeam gas grills : Target

Shop for sunbeam gas grills online on Find sunbeam gas ... gas grill will have you grilling in minutes on ... break..I won't buy another ...
Read More At :

BBQ Ribs On A Gas Grill - SavoryReviews

This worked perfectly as I have been getting a lot of emails about how to cook ribs on a gas ... For my first time grilling ribs I was ... It won’t really do too ...
Read More At :

Suggested Questions And Answer :

Gas will not flow to burner to light grill?

The new style OPD valves have a small brass ring located in the female fitting on the LP tank. Over time this ring can work loose and then it does not allow the male fitting to fully depress the OPD valve thus reducing your gas flow Using a small flat bladed screw driver tighten the small brass ring This should solve your problem
Read More At : Capt'n Cook 4-Burner (NG) Grill...

Gas will not flow to burner to light grill?

Could be the reg on the tank , not working no flow of gas ,
Read More At : Capt'n Cook 4-Burner (NG) Grill...

This is for a webber performer grill. It was popping and the flame was erratic so I cleaned it according to the instructions. Now it has worked perfectly for a couple months, but recently it won't light. The gas is full. The grill and orifice are clean. Usually I could hear a jetting sound at the burner if it was not lit. The normal sound of gas russing into the tube. Now there is no sound. The igniter still works and it will light right at the orifice, like a piolet light. But there is no pressure and no flame. If I take the orifice clip off and take out the orifice, then turn on the gas, there is barely any gas. Could it be a bad regulator? Is this a warrenty item? Mike Farmer 630-453-3448

Mike, it may be a bad regulator, but is may also be correctable without buy any parts.To solve the problem do the following:To solve this problem, first be sure you have adequate gas in the tank. If that checks out OK, do the following: 1. Turn the gas tank valve OFF and disconnect the hose from the tank. 2. Wait 5 minutes and reconnect the hose to the tank. 3. Open the tank valve VERY, VERY SLOWLY (Slow motion, slow). 4. Once the tank valve is fully open, light the burner farthest from the tank first and set the burner control knob on HIGH. Does the flame height look correct for being set on HIGH? If so, light the remaining burners the same way. Do all the burner flames look correct? If so, you solved the problem. Remember, to always open the tank valve Very, Very Slowly. If that didn't solve the problem, you will need to replace the grill's Hose/Regulator Assembly. It runs about $30.00 at any home center or hardware store that sells grills & accessories. If you replace it, turn the tank valve ON Very, Very Slowly. Hope this helped you to troubleshoot and solve the problem. Happy Grilling!! Thanks for choosing FixYa.
Read More At : Performer Grill...

Grill mysteriously not working, gas tank full, can't smell or hear gas come to burner

Go to Dome Depot. Lowes or whomever your large hardware store is and get and new regulator and connecting kit (it is probably the regulator), they are not expensive. If this does not do it, it may be the valve on the broiler, but not likely.
Read More At : Grilling...

I have a stainless steel Kenmore propane grill, model 119.16311800. It has four burners and a side burner on the left. It is two years old and has performed perfectly for two years. I am now having trouble with the flame. It will light and if I only have one burner on it will give a good flame. Lighting additional burners will reduce the flame size, when all four main burners are on they struggle to stay lit. We recently moved, and the grill was out of gas for an extended period. The problem first presented after a relative gave me a gas tank. Initial inspection showed some debris in the valve of the tank itself. I tried removing the debris from the tank with partial success. I connected it to the grill and had the same issue. Got a new tank. Fired up and cooked up some great burgers. thought I was all set until the next time when the new tank also produced the same results. I have not been able to disassemble the burners to check/clean the venturi tubes. (ever) It appears that there is a screw at the rear of the burners that will release it, but they are badly corroded and will not come out by standard means. If you could confirm this is indeed the proper way to remove the bruners I will drill them out and devise a better way to fasten them afterwards. Also, I did read here about opening the gas tank valve very slowly. I disconnected the regulator, waited a few minutes, reconnected and opened very slowly. Light the furtherst burner first and proceeded to find the problem still existed. I understand that the regulator may also be faulty. Given that there is no gauranteed life cycle for any product, can you estimate a typical life span for a regulator? How would I go about checking the regulator? I fear that when I tried to remove the gunk in that old tank some loose particals may have gotten into the regulator and damaged it. Thank you very much for any assistance you can give!

With all the you described, your best bet is to replace the grill hose/regulator assembly. It's not expensive and it's not difficult to do. You can find the hose/regulator assembly at any home center or hardware store that sells gas grills. The assembly is universal, but take your old one with you for comparison purposes.As far as replacing the burners are concerned, that's not difficult either. And you may be able to find the replacement burners at , as they made the Kenmore grills for Sears. And yes, the scenario you gave for removing the burners is correct.Hope this helped you and you will be kind enough to give my response to you, a positive rating.Happy Grilling!
Read More At : Kenmore...

Gas Not Flowing

Try this. Turn tank off, open all three burners for a minute or 2. Close burners. Open tank very slowly. Open primary burner, (usually the front burner) and try to relight. Should work, but if not check that valve is secured to tank and check for leaks with soapy water.
Read More At : Genesis Gold B Premium Grill...

I have a kenmore gas grill that has the side burner. Up until recently, it has been working great. However, now the main grill won't light when pressing the ignition button but the side burner lights instead (something we rarely use!!). We can manually light the grill but it is only 1 1/2 years old - help! Thank you! DMac

More than likely, the electrode spark ignitors on your main burners need to be cleaned. They will get covered with grease over time. Also check the wiring from the ignitor module to each spark ignitor being sure that all wiring is firmly in place. To clean the electrode(s) ... a cotton ball dipped in alcohol will work fine.Hope this helped you solve the problem and Happy Grilling!
Read More At : 700 sq. in. Cooking Area Gas Grill 14116325...

Gas grill lights but doesn't get very hot

I had this same problem especially when the tank on my 5 burner 2 year-old Kenmore was about half full. The solution above fixed it. I was used to opening the gas fully, turning one burner to high and clicking the button. If I would have read the front of the grill I would have seen that this was incorrect. I turned off the grill completely, unhooked the regulator and reconnected it. With one burner on high I began clicking the button BEFORE I turned on the gas. I slowly turned the gas on one quarter turn and it lit up full flame. I slowly turned the gas another quarter turn and lit the second burner. I slowly opened the gas all the way and lit the third and so on. That did the trick!
Read More At : 700 sq. in. Cooking Area Gas Grill 14116325...

Gas grill will not light properly after you change gas bottles

Hello,This is a common problem. Try turning off the propane tank valve and disconnecting it. Then reconnect it and very slowly turn the tank valve back on. Make sure the grill burner gas valves are all off before you do this. When you turn on each burner, do it slowly and one-at-a-time. Hopefully this will solve your problem. If not, there could be other issues that we can discuss in detail, if needed. Douglas
Read More At : 16691 Grill...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0476 seconds