Guide :Grilling : Grilling

Rotisserie won't stay lit

My Jenn-Air (model #720-0336) grill is brand new and I just tried to use the rotisserie burner and it keeps going out after it gets hot. It does not re-lite by itself...right??? I am so frustrated as people are waiting for my first chicken cooked this way. HELP!!!!!!!!

Research, Knowledge and Information :


BBQ Grill Rotisserie Burner Won’t Stay Lit — Gas Grills ...


When the barbecue grill rotisserie burner will not stay burning this is how to repair your bbq grill.
Read More At : www.grill-repair.com...

Rear rotisserie burner won't stay lighted | Rasmussen Solaire ...


solaire, rotisserie, rear burner, won't stay lighted, won't light, lit
Read More At : rasmussen.host4kb.com...

DCS rotisserie burner won't stay lit - BBQ Source Forums


does anyone know how to fix or repair the thermocouple on the infrared burner of a rotisserie? We have a DCS 30" grill. The rotisserie burner has always been...
Read More At : www.bbqsource-forums.com...

ROTISSERIE BURNER Won't light! - BBQ Source Forums


ROTISSERIE BURNER Won't light! Sign in to ... when you lit the jet at the rotisserie burner, ... Some rotisserie have a thermocouple near the jet, ...
Read More At : www.bbqsource-forums.com...

infrared burner not staying lit - Houzz


Hi all I just bought a gas grill with a rotisserie and I went to try it out and the infrared burner would stay lit for about 3 minutes and then it would go from ...
Read More At : ths.gardenweb.com...

Gas Grill won't stay lit - DoItYourself.com Community Forums


Gas Grill won't stay lit ... Got it here and reassembled the sides and the gas tank and the thing won't stay lit. First try i thought i had it and it lit, ...
Read More At : www.doityourself.com...

Weber.com - Support - Help - Faqs


Top Faqs How do I view more FAQs ... Why won't my charcoal grill get hot? ... Should the motor for my rotisserie be stored indoors?
Read More At : www.weber.com...

Suggested Questions And Answer :


Grill wont stay lit


These new tanks have a safety device installed in them . If you open the valve quickly or tip the jug the damn thang won't work. Take the tank loose, open all the grill valves and close all valves. Reconnect the tank and SLOWLY open the valve a hair. Light the burners. No need to open the valve all the way. if you do the dumb safety will plug the jug.
Read More At : Charmglow 810-7600-S Grill...

Problem with Rotisserie - Viking Gas Grill


Hi Did it behaved the same way when it was on NG or the issue started after the conersion from NG to Propane. Be certain you are pressing the battery ignition button (T-Series only) corresponding to the burner you are lighting. Open the hood or remove covers. Push and turn the control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel and continue to hold in the knob. Press the electronic ignition button corresponding to the burner being lit. You will hear a clicking sound. After the burner lights, hold in the control knob about 5 seconds longer or until the burner remains lit. Turn the control knob to the desired setting. If the burner does not light in 4 seconds, turn the knob to “OFF” and wait 5 minutes before trying again. This will allow accumulated gas to dissipate. After several failed attempts the burner can be lit with a paper book match using the flash tubes. If you have just attempted to light the burner with the ignitor, allow 5 minutes for any accumulated gas to dissipate. Please see this instructions manual for more details to fix this problem with your viking grill -- Viking Gss Grill VGB (T-Series) Please do accept this solution and revert for further assistance. Thanks Rylee
Read More At : VGBQ410-3RT Grill...

My weber genesis wont stay lit. i can light the


The new style OPD valves have a small brass ring located in the female fitting on the LP tank. Over time this ring can work loose and then it does not allow the male fitting to fully depress the OPD valve thus reducing your gas flow Using a small flat bladed screw driver tighten the small brass ring This should solve your problemIF not you might want to remove the cap (white) on your regulator and try slowly adjusting the regulator, make small adjustments and try the BBQ My Weber if I set the front and back burners to MED I get right at 350 degrees in 60 degree outdoor temps. Adjusting the regulator will take some time to get it right but If it is not your tank it is most likely your regulator out of adjustment
Read More At : Genesis Silver C Grill...

The smoker burner wont stay lit on my grill. I can get it lit but it wont stay on


I had the same problem and I found that if I tightened the thermocouple line on the back of the smoker control knob it would work properly. You can see the thermocouple line brass nut thru the slotted opening just above the double doors and below the control knobs. Mine was only finger tight and as soon as I tightened the thermocouple line nut, everything worked normal. Good Luck
Read More At : 5 Burner with Smoker 8101750S...

Can't keep the Rotisserie to stay on


Called Ducane's customer service. Very helpful, they hooked me up. 1-800-382-2637 is their number. Dave
Read More At : 30400040 Stainless Steel Grill...

My Coleman grill caught fire when my brother left it on on accident, I had to dump water on it to put out the fire, now my grill wont stay lit even though I have plenty of gas... Is my grill broken or is there something I can do to fix it?


Might have water in burner or a melted o-ring from fire
Read More At : Roadtrip Grill LXE 9949-750...

Gas grill Solution for ''i had just purchased a grill about a month ago and now it wont stay lit flame very low in 1 burner and other burners no flame


Probably 1 of 3 things: Check your LP tank valve at an LP filling station. Make sure both valve and tank are in working order.Next check for webs or cocoons up around where knob valves go into burners. You may have to remove burners to see into back of valves. Then swab orifice holes with a torch tip cleaner.Third, a Menards , LP outfitter/station, or grill shop should have a universal replacement rubber gas line and "regulator"(possibly plugged or stuck shut). Sometimes you end up with cheap/bad regulator out of the factory. Good luck and hope one these helps or does the trick.
Read More At : Genesis Silver B Grill...

I've a Swiss grill with rotisserie burner (infra-red) & it keeps blowing itself out, it stays lit for 5mins then suddenly flames pop out & it goes out, it still sounds as if gas is coming out though.


Almost certainly yes. The infrared grills work by gas and air coming through the surface under pressure. The crack would cause lower pressure and flameout. Does it flame at this area? Beyond the nozzle (towards the burner) that you cleared is an area called the venturi, this is where the gas is mixed with air before it hits the burner. check that for blockages.
Read More At : Grilling...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mainebirdfood.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0448 seconds