Guide :Grilling : Roadtrip Grill LXE 9949-750

Propane will not come thru burners

Propane tank is over half full and is turned on as well as both burners. The ignition spark is visible but cannot hear fuel sound or get any flame. The last thing I did to the grill is to thoroughly clean and scrub the entire grill with soap and pressure water.

Research, Knowledge and Information :


Fixes for Common Gas Grill Problems - Make Your Best Home


Common Gas Grill Problems ... Turn off the gas at the propane tank; ... If you have independent ignition and one of the burners will not light, ...
Read More At : www.thespruce.com...

Gas (Propane) Furnace Startup Sequence - Troubleshooting HVAC ...


Mar 05, 2011 · This video clearly shows how a Gas (in this case an LP Propane model) furnace starts up. The same startup and timing sequence applies to a natural gas ...

Why Won't My Gas Grill Get Hot? - Home Ec 101


Why Won’t My Gas Grill Get Hot? ... Completely shut the valve on the bottle of propane. Turn off all of the burners. ... Squirrels have chewed through my regulator ...
Read More At : www.home-ec101.com...

Easy DIY Gas Grill Repairs If the Burner Won't Light | Sears ...


Easy DIY Gas Grill Repairs If the Burner Won't Light . ... Make sure the propane tank has gas ... How to Test Gas Grill Burners. If the tank and hose are not the ...
Read More At : www.searspartsdirect.com...

Troubleshooting RV Furnace Problems - beamalarm.com


Troubleshooting RV Furnace Problems. ... air flow through the furnace a bad propane valve at the furnace or a ... if not obtainable. B) Check burner ...
Read More At : www.beamalarm.com...

LP Gas Not Flowing To Appliances - Systems and appliances ...


LP Gas Not Flowing To Appliances Sign in to ... opened all 3 burners using a long lighter this time and still no fire. ... I am not getting propane to anything.
Read More At : community.fmca.com...

Bad propane regulator? Resetting it? - BeerAdvocate


At first I had no propane at the burner. ... Bad propane regulator? Resetting it? ... then blow through and clean everything as much as possible.
Read More At : www.beeradvocate.com...

Suggested Questions And Answer :


Burner 1 and burner 2 from right to left work very well, burner 3 acts as if the regulator is malfunctioning. Comes on very low, blow back thru the regulator tube. Multiple trys of turning off gas, disconnecting and resting the regulator, with 1 and 2 working perfectly with minimum propane turned on but number three will not work, still acting if the regulator was malfunctioning


try cleaning burner 3 could be blocked , or it could be split , the air mix could be wrong you can move the air mix slider to give more or less air , see if the orffice is blocked . or you could try changing the reg but don't see that being the fault.
Read More At : Big Gass III - SPG-90B Grill...

Propane will not come thru burners


Most propane problems are due to a new valve on the top of the tank. It is designed to only allow a minimal flow until the line is pressured. This prevents fire flair up from broken or leaking hoses. Always turn the bottle on and wait before trying to light a burner. If the burner is on first, the propane will never come out at full flow or if you have a leak in the system, it won't pressurize sufficiently to allow full flow out of the bottle. There is never "air" in the tank.
Read More At : Roadtrip Grill LXE 9949-750...

Gas coming out near burner knobs


The issue is with the valve that is connected to the knob. it is poorly designed. To fix it take off the lid assembly and remove the front black cover that covers the knobs. remove the almost diamond shaped metal piece that the knob shaft runs through. put on your gas tank and adjust the valve to a position where no gas comes through.. might be lucky or you will have to replace that valve.
Read More At : Roadtrip Grill LXE 9949-750...

My coleman roadtrip grill is new/unused. I followed all the directions for set up the propane tank and the burners will not light. i can't hear anything and it seems like the propane is just not making its way to the burner. i've taken it on and off and read the instructions over and over, but i can't get the burners to light. help!


If you don't mind turning OFF the tank vale and disconnecting the hose one more time, follow these instructions.Starting with the tank valve Off and the hose disconnected, turn the burners on for 1 minute and then turn them OFF. Wait 4 more minutes, reconnect the hose to the tank and turn the tank valve ON VERY, VERY SLOWLY. (Slow motion, slow). Once the valve is full open, light one burner and turn it to it's highest setting. Is the burner lit and burning? Does the flame height look correct? If so, light the remaining burner, repeating what you did with the first burner. Does this burner's flame height look correct? If so, you solved the problem.If it didn't solve the problem, check to be sure, there's actually enough gas in the tank to sustain combustion. If that checks out alright, you have two options. 1.The grill is still under warranty, contact Coleman for repairs or replacement 2. Depending on how long ago your bought it, return it to the place of purchase for a refund or replacement. In either scenario, you will need your Proof of Purchase.If you completed everything I suggested and the burners still aren't getting gas, it's a case of manufacturer defect. And yes, it does happen.Good luck. I sincerely hope it all works out for you and you solve the problem.
Read More At : Roadtrip Grill LXE 9949-750...

No propane flow to grill using bulk bottle system.


I have a new Coleman Roadtrip LXE. They will not work with a regulator on the suply tank. They work fine off a bottle or a bulk tank, again without a regulator. The regulator on the stove is not adjustable and when it is supplied with 11" wc (low pressure) it futher reduces the pressure so low the flame goes out. I attached mine to my toyhauler quick connect fitting, the gas pressure at the outside valve is regulated at the tank. This won't work, it only works if I hook the bulk tank or 16 oz bottle to the stove.
Read More At : Roadtrip Grill LXE 9949-750...

I have a coleman roadtrip grill. I use a propane screw in canister. When I lite up the grill there is a flame that comes out by the propane cylinder were is screws on the back of the grill. How do I fix this?


There is no repair. The canister holder/control valve will have to be replaced. You can contact Weber directly at 800-446-1071. If they don't have it try Appliance Factory Parts http://www.appliancefactoryparts.com/ They have a large selection of replacement parts for all makes & model grills.Good luck and Happy Grilling!!
Read More At : Roadtrip Grill LXE 9949-750...

Have a large mobile propane grill with burner problems


Ok, here is a check list for your most common gas grill lighting problems:1) Check your tank. Is it empty or nearly empty? The tare weight (T.W.) of your cylinder is stamped on the collar. This is the weight of your empty cylinder, usually around 18 lbs. Weigh it on your bathroom scale. Propane weighs 4.25 lbs/gal. If it weighs around 20 lbs or less - Refill it. If not, go to #2.2) Make sure you didn't turn the gas tank valve on too fast. Some gas hoses have a built-in excess flow valve that stops the flow of gas to a trickle if opened too fast. Close the tank valve and let sit for a few minutes. Or just disconnect it and reconnect it. Turn the tank valve very slowly and then try lighting it again. If it doesn't help, go to #3.3) Is the igniter sparking? Some are battery powered-check the battery or replace it. If you have a standard push button piezzo igniter or a rotary style igniter, check for spark. Can you hear or see the spark? It's hard to see the spark in bright daylight. It's easier to view the spark at dusk or dawn. It should spark an "arc" at the burner. If not, adjust it if necessary. The igniter wire may have a short, causing the spark to arc somewhere else along the wire and not at the burner. Replace igniter wire. It's also possible the igniter tip where it sparks has a cracked or broken porcelain portion of the igniter, causing the spark to not arc at the tip where it's supposed to. Replace the igniter piece. If not, go to #4.4) You may have a rusted, clogged or damaged burner or venturi tube. With a flashlight, check for spider webs, wasp nests or dirt (mud) dauber nests in the opening of the venturi tube where it connects at each gas valve orifice. Clean it out manually or blow it out with air compressor. Make sure the air adjustment opening (on the end of the burner's venturi tube) has not been changed. If it's closed too much, it will be difficult to light and cause lazy yellow flames. If it's not clogged, the burner may just be old and rusted and the burner holes are not allowing very much gas through anymore. It's also possible the burner has rusted so bad, the burner holes have been enlarged, it is falling apart or has cracks along the burner seams. If so, replace the burner(s) immediately. It is unsafe to use. Your local propane co can usually order the parts you need and some will even do the work, if you are uncomfortable doing it yourself. Bring with you the Make, Model and Serial number of the grill, so they can order the correct parts for your specific grill.Have a large mobile propane grill with burner prob - 2_bing.gifify whether it's natural gas or propane.5) If none of these resolve the issues you are having, it is also possible you have a faulty or defective regulator, which may mean replacement. If the pressure still seems too low and none of the above has helped, and you have a silver/gray regulator; many have an adjustment screw on the top center of the diaphragm. Remove the outer cap and turn the inside screw clockwise in 1/4 turns to increase the pressure until the desired flame size is accomplished. Flames should be as blue as possible, but will burn orange if there is food or drippings on it. Yellow flames are not good, and will soot up everything and not cook as hot as blue flames do. Yellow flames could mean you do not have the right air shutter adjustment, clogged burners, or possibly defective burners, as mentioned above in #4. 6) Also make sure you have the hose connection tightened snugly to the propane tank valve to ensure the inner valve seat is fully depressed allowing gas to exit fully without any restriction. The black plastic female fitting should be hand tightened only. Older versions that use a left-hand male brass POL valve, requires a 7/8 open end wrench or adjustable wrench to tighten.Hope this helps! Good luck in your trouble shooting! Douglas
Read More At : Extra Large - XLHD All-in-One Grill / Smoker...

My propane tank is full, but none of my 3 burners come on, 1 does very slightly but then goes out, help! thanks


Turn the propane tank valve to OFF. Disconnect the hose from the tank and wait 5 minutes. Then, reconnect the hose to the tank and turn the tank valve ON VERY, VERY SLOWLY (Slow motion, slow). Once the tank valve is fully open, light the burner farthest from the tank first and turn the burner knob to high. Does the flame height look as it should? I f it does, light the remaining burners the same way, one at a time. Do all the burners burn as they should? If so, you solved the problem. If not, you need to replace the grill hose/regulator assembly. You can get one from any home center or hardware store that sells gas grills and accessories. Just take your old one with you for comparison purposes.Hope this helps and Happy Grilling!
Read More At : Charmglow Stainless Steel LP Drop-In 4-Burner Grill......

Grill won't start


If your sure the propane tank is full, and the valve is open, (counter clockwise, and the control knob is on? you should not only smell it after 20 seconds, but if you put your ear near the grill you should hear a sound like air leaking.If you hear nothing and smell nothing, good chance there is a blockage in the line, or the burner holes are filled with drippings. First off, get a wire brush and scrub the burners where you see the small holes that the flame normally comes out of, then try the grill again, if still nothing (and your 100% sure the tank is full, the tank is on, and the control knob is on high) you may need to start taking apart the grill, looking for a blockage, many times its below the control knob where you will see an adjustable screen, spider webs and such will get in there and block the flow. Remember to not do any of that with the tank on the grill, remove the tank first.;
Read More At : Q 320 Propane Grill...

We have a spirit grill with 3 burners. I can light the grill, but burners 1 & 2 don't have a nice line of blue flame like burner 3. Burner 2 is especially bad with orange flames on the right and left end. Burner 1 seems uneven. I tried brushing the spider stopper guards, but it didn't seem to make a difference. What can I do?


Are you sure there's adequate gas in the tan? If so do the following:Disconnect the LP tank from the grill hose. Wait 5 minutes and reconnect to the tank. Open the tank valve VERY,VERY SLOWLY, until it is full open. Light your burners individually and turn to highest flame setting, before lighting the next burner and so on.If that solved your problem GREAT. Remember to turn the tank on that way in the future.If it didn't you'll need to remove the burners and clean each one.Hope this helped to get you back up and grilling again.
Read More At : Spirit? E-310 Propane Grill...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mainebirdfood.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0851 seconds