Guide :Grilling : Patio II Grill

Both burners seem to explode at different times

I have had one, for a while, of my burners make this boom sound extinguishing the infrared burner during cooking but still glows at the bottom making a hissing noise. Now the other burner is doing the same thing. It scares the heck out of you if you are standing in front of the grill cooking. You can turn the grill off & relight the pilot light and start the burners back up after it cools down. It only takes a few minutes to blow up again. Both burners are doing it now and I have the cooking dial below the halfway mark with this occurs. What do I need to do to fix this problem & apparently hug

Research, Knowledge and Information :

electrical - Why do the burners on my stove turn on and off ...

I've got a Whirlpool RF378LXPB0. The two front burners (that can heat a smaller, inner burner, or both the small and larger around it) do not heat up all the way.
Read More At :

The deal with Creatine + Fat Burner -

What's the deal with using creatine and a fat burner ... namely that you should not take both at the same time. But would taking them at different times of the day be ...
Read More At :

Foot Pain - In-Depth Report - NY Times Health

Cramping and burning pain, ... Look for thick or discolored nails ... Put a rubber band around both big toes and pull the feet away from each other.
Read More At :

Brain Tumor Symptoms

Brain Tumor Symptoms ... Dear Ann Our thoughts and prreyas continue to be with you and Randy as you both look ... never went but got better at different times ...
Read More At :

How Fast Does Black Powder Burn? -

Explains how fast black powder burns in different ... I take a look at how these burning rates can be measured and ... to speed up the powder's burning time.
Read More At :

7 Things You Should Know about Fire Pits -

7 Things You Should Know about Fire Pits. ... Gas or wood burning: ... For both permanent and portable fire pits, ...
Read More At :

Forge and Burner Design Page #2 - ABANA

(This page is a continuation of page #1 of the Forge and Burner ... concrete to explode and blast ... of hole for both purposes. Please have a look at the ...
Read More At :

astronomy 130 quiz chapter 20 Flashcards | Quizlet

Start studying astronomy 130 quiz chapter 20 ... Red giants have a hydrogen-burning shell, whereas AGB stars have both a ... High-mass stars explode as ...
Read More At :

Suggested Questions And Answer :

Both burners seem to explode at different times

I had the same problem. I disassembled the grill and found that both burner box assemblies were shot. With these being worn out too much air was being mixed in the assembly. You'll need two burner box assemblies...not cheap! You'll also need new gaskets
Read More At : Patio II Grill...

We have a spirit grill with 3 burners. I can light the grill, but burners 1 & 2 don't have a nice line of blue flame like burner 3. Burner 2 is especially bad with orange flames on the right and left end. Burner 1 seems uneven. I tried brushing the spider stopper guards, but it didn't seem to make a difference. What can I do?

Are you sure there's adequate gas in the tan? If so do the following:Disconnect the LP tank from the grill hose. Wait 5 minutes and reconnect to the tank. Open the tank valve VERY,VERY SLOWLY, until it is full open. Light your burners individually and turn to highest flame setting, before lighting the next burner and so on.If that solved your problem GREAT. Remember to turn the tank on that way in the future.If it didn't you'll need to remove the burners and clean each one.Hope this helped to get you back up and grilling again.
Read More At : Spirit? E-310 Propane Grill...

Propane grill uneven heat

Make sure the burner are clean. Or Just purchase a Weber. There customer service is #1
Read More At : Grilling...

Our grill was assembled 1 year ago by home depot. we have used it 5 times since. the first two times it seemed to work perfectly. since it only incompletely heats and has a gurgling sound in the burner area when on. we have replaced the gas with a new full bottle, the next time it worked perfectly. however now it's doing the same thing. It will not heat up and has a gurguling sound in the burner area like its being blown by wind.

Turn on the burner that lights with the ignition, watch as the other burners come on, if the flame gets lower as each burner comes on, you probably need to replace the hose and regulator.
Read More At : Genesis E-310 Gas Grill...

Natural gas grill low flame

Did you change the reg , lpg burns at 14 inches wg nat gas burns at 4inches wg
Read More At : Commercial Stainless Steel Grill...

I just purchased a new portable gas grill. Burner Is melting.

Take it back for a refund as it is not fit for the purpose
Read More At : FG2204C Grill...

I have a 3 or 4 year old Genesis Three Burner Weber Grill. The grill when turned on would only get up to about 250 to 300 degrees. I bought a new regulator and hose and it seems no gas was going to the flame tubes . . . no smell of gas. I bought another regulator and hose and no gas again. Then I turned the gas tank valve on slowly and the gas came out. I got the temperature up to 550 degrees. Great! The next time I turned the gas on and tried to start the grill, again, no gas flowing. I turned the tank valve on slowly several times but to no avail. What is the problem? Thanks, Alan

The gas in the bottle is not a just pure gas but it is contain also very small quantities of oils and dirt. So with long time use they are creating a thin layer over regulator and valve parts, like springs and injector rods which make them to stuck. This what is happening with th tank gas valve which you may turn the regulator but the inside parts are stuck. Sometimes if you hit a litle bit it can work again but this is not a solution. The solution is to replace the tank gas valve with new one. Also you should know that since you have this problem with tank valve then most posible to have also some problem with burners gas valves in the future. One way to avoid this and also with the new tank valve is when you realise that the gas tank is almost empty the is better to replace the tank since the last gas in geting out the most of the above mention oil and dirt and end on the valves.
Read More At : Genesis Silver B Grill...

We seem to be having the same problems as some of the others. Our sons bought this grill for my husband for Father's Day. I came assembled. There is a kink in the hose (the one that has to bend to attach to the center burner. So we are unable to get any gas flow to the grill. We went up to Home Depot with the slip to see if they would give us a new hose that was not kinked. However, every single Brinkman there had a kinked hose. The problem is that the hose it too short. It needs to span too big of a distance and then when it turns the corner to attach to the main central burner, it just kinks preventing gas from getting through. We are now looking for a replacement hose assembly. If we cannot find one, we will return the grill and get a different brand. Do you have any suggestions

Home Depot will not be able to help you with this. You should contact the manufacturer, Nexgrill, directly and see if they have longer gas lines as this seems to be common on this model of grill. There may have been enough complaints that Nexgrill has new lines available. This is also fairly common among all Chinese import grills that like to cut corners on costs.
Read More At : ProSeries 810-6330-W Grill...

I have a new Vermont castings Signature Series 401 Natural gas grill. Even when the burners are set on high there doesn't seem to be a very big flame on any of the burners and with all the 4 burners on high the temp with the lid closed will only get up to 350 degrees. I have tried adjusting the oxygen intakes on each of the burners but it didn't make any difference. Any Suggestions?

You may have a new VC Natural Gas grill, but I'm willing to bet that it has LP Gas Orifices in it, instead of natural gas ones. Sometimes this happens. It gets mismarked as Natural Gas, when in fact it's Propane.To confirm this, remove a burner, then remove the orifice, It should be stamped for which gas it's for. It will say NAT or LPG or LPIf you find this the problem, contact the VC dealer you purchased it from, for No Charge replacement orifices.Hope this helps you to troubleshoot and solve the problem
Read More At : Signature VCS4028N Stainless Steel Gas All-in-One Grill /......

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || || Terms of Use || Contact || Privacy Policy
Load time: 0.0826 seconds