Guide :Grilling : 16228 Grill

Flame low on grill however the flame is high on burner

The grill burners are low.. wont get higher.. what can I do? Tony

Research, Knowledge and Information :


How to Troubleshoot a Gas Grill With a Low Flame | Home ...


There are many areas of concern that can cause low flames, ... to Troubleshoot a Gas Grill With a Low Flame. ... grill lid open, turn the burner knobs to high for ...
Read More At : homeguides.sfgate.com...

Fixes for Common Gas Grill Problems - Make Your Best Home


Common Gas Grill Problems ... Low Flame, Low Temperature, ... Turn all control valves to high (including the side burner if you have one)
Read More At : www.thespruce.com...

Low Flame on Propane Grill - How to Start a Gas Grill


Jun 10, 2013 · Low Flame on Propane Grill ... If you have a low flame on your grill, ... Wait at least one minute before you turn on the burner to start the grill.

Tips for Dealing With Low Flame Issues - About.com Food


Sometimes your burner might have ... Open the grill lid, turn all control valves to high, ... For more information on tips with dealing with low flame issues on ...
Read More At : bbq.about.com...

What does it mean when a propane grill has a low flame? How ...


What does it mean when a propane grill has a low flame? ... Open the main burner slowly - normally - to high and light ... What is the average temperature of its flames?
Read More At : www.quora.com...

Propane with orange flame - BBQ Source Forums


Propane with orange flame ... flame at the burner site, especially at high heat ... either too high or too low for the settings on the Char Broil grill, ...
Read More At : www.bbqsource-forums.com...

Range Gas Burner or Oven Flame Too High or Uneven


Range Gas Burner or Oven Flame Too High or Uneven. Most gas ranges and cooktops are set for natural gas at the factory. If the burner or oven flames are too high or ...
Read More At : products.geappliances.com...

Preventing low flames on gas grill |Char-Broil®


Preventing Low Flames on Your Gas Grill. You’re looking to get that really good sear with a high temperature but your grill is ... a low flame is that the ...
Read More At : www.charbroil.com...

Suggested Questions And Answer :


Low flame I have a Frigidaire 4 burner LP gas grill that does not get hot past the low end of the "Grill" meter when all 4 burners are on. When all burner are turned to high you barely see any flame. When I turn on any 1 of the 4 burners you at least see a flame better than before but still not good. The unit is sealed other than looking at the burners. I have tried the following: 1 Looked for a kink in the hose 2 Check the gas tank (put a new one in also) 3 Cleaned the gas lines


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly worded...2. the question is mis-categorized - so the correct experts aren't viewing it...3. the question requires an answer for something that cannot be explained online adequately...4. specific training, tools, or equipment are required to avoid injury or death...5. the Experts that are online simply don't have the resources to answer your question fully...Please feel free to re-work your question if you feel one of these may be the reason.Of course you are not required - but converting your question to a PAID one usually increases the reply rate as well.Normal rates for FixYa are...$ 9.99 answer for one question.$12.99 Live Real-Time online chat or premium e-mail support.$29.99 Live Real Time phone supportSometimes FixYa will run specials for unlimited questions via monthly subscription or reduced rates for limited periods.Consider the savings that can be had when an informed Expert can save you a $100 service call, or a $350 trip to the car dealership.Your problem solved - guaranteed! Or your money back!!If you don't want to pay - feel free to re-submit your question so it returns back to the top of the work queue if you still need help.Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question
Read More At : FD38NGDC Grill...

I have a jenn air 3 burner grill purchased 4 years ago new (from either lowes or home depot). I use propane tank for fuel (which is 1/2 to 3/4 full at the moment). The issue I am having, is when I turn on any two of my burners and go to light the third; both of the previously lit burners flame way down (burners are still on high!!) and sometimes one will flame out, or they both flame way down and the third burner will not light. When the third burner is turned off, the other two do not come back onto high, they stay at a very low flame. HELP!!!


It sounds like it is a natural gas grill instead of propane change out your orifices
Read More At : Grilling...

My grill burners burn unevenly and usually too high. Adjustment?


If this is a natural gas grill, check to see if it has a regulator on the gas line. If it does not, you can install a regulator to reduce the gas flow.
Read More At : Commercial Stainless Steel Grill...

Will not produce high flame properly


You probably have a bad regulator which you can buy at most stores that sell BBQ's.
Read More At : Performance 463463006...

Flare behind temperature knobs on jenn-air gas grill


This seems to be a problem for most Jenn-Air users. The burners are defective, rusted or clogged and allowing the flame to "back up." You most likely have a melted electronic ignitor as well as gas valve damage. The new burners that I received this week for my model 720-0061-LP are 1/2 inch shorter than previous versions. Time will tell if this fixed the problem. I would call Nexgrill and get all new burners and inspect the gas valve area for damage. Since 2004, I am on my 5th set of burners, glad they were free since I have a lifetime warranty on my model.
Read More At : Grilling...

Flame low on grill however the flame is high on burner


Had the same problem. Belive it or not i basically follow the turn on instructions. Disconnet the regulator, let it stand for five minutes, the reconnect and turn it on 1/4 and turn the burner that is at the end of the line. (in my case the is the first one on the left).
Read More At : 16228 Grill...

My 1100lp when burners are on low flame is to low and make squeeking noise and if a slight bit of wind will blow out flame. I cleaned burner tubes and replaced regulator with factory parts will heat up on high but any of the 3 burners all act the same.


Turn off the LP Tank, disconnect the hose from the tank and wait 5 minutes. Reconnect the hose and turn the tanl valve on very, very slowly, until it's fully open. Light each burner and turn it to high. Wait for the burners to heat up and turn them down gradually to low. If flame height on low has returned to normal, the problem is solved. If that didn't solve the problem, the air shutters on each burner may need adjusting. Consult the installation instructions that came with the new burners for the proper setting or consult your Owners Manual.If it's real real cold outside, it's not unusual for the burners set on low to have a problem. The only solution to that is let the grill preheat well, before turning the burners down. Also, grill with the hood closed on low, if it's a windy day.Hope this helps you and gets you back to grilling again.
Read More At : Genesis Silver A Grill...

My Weber Q grill worked great for 5 years but now it won't light on one corner and I can't get a high flame on any part of the burner. Even on "high" the flames are small & blue and the heat level is low. Would like some advice on what is wrong & how to fix it. Thanks!


Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} Hi, You problem could be or probably is with the regulator...not enough gas pressure... Propane, LP, or Natural Gas Regulator Problems heatman101
Read More At : Q Grill...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.mainebirdfood.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0798 seconds